Races are won or lost in fractions of a secondDynojet's Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applicationsThe shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configurationRequires modification of gear-linkage tie-rodThe linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fitMount one end to the shift lever and the other to a fixed point on the chassisPush or pull-types available with universal mounting kitPlugs directly into the Power Commander expansion port with no re-wiring requiredPower Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operationPART #s 1601-0011 and 1601-0012 are "pressure style" sensors for PCIII USBPART #s 1601-0244 and 1601-0245 are "pressure style" sensors for PCVPART #s 1601-0327 and 1601-0328 are "linear" sensors for PCIII USBPART #s 1601-0329 and 1601-0330 are "linear" sensors for PCVNOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required.